ECP 585 Static Dissipative Aerosol Coating Paint

 ECP 585 is a single component, light grey coloured acrylic paint in aerosol form to provide a convenient method of application for prototype, design and touch-up work in order to give anti static properties to products used in the electronics industry. It is specially formulated to minimise settling and to provide a homogeneous finish.

Physical properties

• Surface resistivity at 50 micron (2 thou) ASTM D257 <10⁹ ohm/sq or less
• Colour - light grey
• Coverage approximately 6 square feet
• Recommended dry film thickness 50 micron (2 thou)
• Drying time touch 15 minutes, full 12 hours
• Contents 400 ml
• Shelf life 12 months

Method of Use

Surface preparation - all contaminants including mould release, grease and dirt must be removed.  Mask areas that do not require spraying.

Mixing - shake vigorously for a minimum of 2 minutes to evenly distribute contents.  Spray a small area to check compatibility with substrate.

Application - operate in an upright position spraying in light, even strokes from side to side to avoid flooding.  Shake briefly at intervals during spraying.  On completion, invert the aerosol and spray to clear valve and nozzle.  It is advised to clear any excess material from the nozzle at frequent intervals to prevent blockage.  If the nozzle blocks, use a pin to clear the opening or remove the nozzle and flush with Toluene, Xylene or MEK.  It is advised to coat several thinner coats than try to coat heavily in one pass.

Precautions - pressurised container.  Protect from sunlight and do not expose to temperature exceeding 50⁰C.  Do not pierce or burn even after use.  Do not spray on an open flame or any incandescent material.  Keep away from sources of ignition - no smoking.  Use under well ventilated conditions -contains inorganic fillers/xylene mix/toluene.  Harmful by inhalation.  Do not breathe vapour.  In case of insufficient ventilation wear suitable respiratory equipment which must be used in accordance with manufacturer's instructions.  For excessive vapour inhalation remove to fresh air and summon medical attention.  Avoid contact with skin and eyes, in case of skin contact wash with soap and water, dry and apply work cream.  Eye contact - flush with water for at least 15 minutes and seek medical attention.  If accidentally swallowed summon medical attention. 

Call TBA Protective Solution on 44 (0)1706 647718 to talk to an anti static dissipative coatings expert.

The above information is given in good faith but no liability will be accepted by the company in relation to the same.  The acquisition of additional information may necessitate revisions to parts or all of this data sheet and such information will be supplied as it becomes available.  As the company's products are used for a multiplicity of purposes and as the company has no control over the method of their application or use the company excludes all conditions or warranties express or impled by statute or otherwise as to their products and or their fitness for any particular purpose.  Any technical co-operation between the company and the customer is given for the customer's assistance only and without liability on the part of the company.