ECP 537 Static Dissipative High Temperature Paint

 A single component static dissipative silicone/acrylic coating which provides excellent anti static protection in addition to its anti-corrosion properties.  Continuous heat resistance is provided up to 350⁰C. Used in areas where ESD (electro static discharge) is to be avoided.

Typical applications would include oven interiors, flow solder machines etc.

Composition

Phenylmethyl polysiloxane resin/acrylic resin/conductive mineral additive/titanium dioxide.

Physical properties

• Surface resistivity 10⁸Ω sq. (ASTM D257)
• Colour - light grey
• Specific gravity 1.3g/cc
• Coverage approximately 4 - 6 sq.mtrs/ltr
• Drying time (air) 1 hour touch dry
• Stoving at 220⁰C 10-15 minutes
• Shelf life 6 months

Availability

ECP 537 is available in 5 and 20 litre cans.

Application

Surface preparation - all contaminants including mould release, grease and dirt must be removed.  A suitable primer may be necessary on certain substrates.

Mixing - some settling may occur in the can so care must be taken to mix in all solids.  Should any dilution be necessary ECP 537 thinners should be used.

Application - ECP 537 can be applied either by a conventional spray gun (40 - 50 psi pressure) or by brush coating.

Stoving - allow parts to air dry for a minimum of 24 hours then oven cure at a temperature of 100 celsius for approximately 10 minutes.

Precautions

Highly flammable.  Keep away from heat, sparks and open flames.  Keep all containers closed when not in use.

Use under well ventilated conditions.  Personal respiratory protection should be worn under spraying conditions.  Such deviced must be used in accordance with the manufacturers instructions.

Avoid contact with skin.  Wear protective gloves and clothing.  Wash thoroughly with soap and water after use.  If accidentally swallowed seek medical advice.

Call TBA Protective Solutions on 44 (0)1706 647718 to speak to an anti static dissipative coatings expert.

The information above is given in good faith but no liability will be accepted by the company in relation to the same.  The acquisition of additional information may necessitate revisions to parts or all of the above and as such information will be supplied as it becomes available.  As the company's products are used for a multiplicity or purposes and as the company has no control over the method of their applications or use, the company excludes all conditions or warranties express of implied by statute or otherwise as to their products and/or their fitness for any particular purpose.  Any technical co-operation between the company and the customer is given for the customer's assistance only and without liability on the part of the company.